Showing 1 of 1848 reviews about:
Tippolas
13
Oct 16, 2019
bookmark_border
star_borderstar
star_borderstar
star_borderstar
star_borderstar
star_borderstar
I've always wanted to try out some planar magnetics and after finally getting my hands on a pair of these I must admit I was quite disappointed. The sound quality is decent but my biggest gripe with these would be the headband. They're extremely uncomfortable. After just a couple hours of usage the top of my head would start to hurt. The padding on them is minimal and you can feel the metal underneath easily. Also, the sliders on the side to adjust fitment of the cans don't seem to stay in place once you adjust them. They move much too freely. After about five days something inside the right can became loose and would rattle with slight movement. Don't know if this is a common issue or not but it rendered the set unusable. Overall I would recommend you spend your money elsewhere.
(Edited)
Oct 16, 2019
Just1Blast
7
Oct 17, 2019
bookmark_border
Are you filing a warranty claim? Why wouldn't you?
Oct 17, 2019
dumb-you
1
Oct 18, 2019
bookmark_border
Comment hidden
help
ThoAppelsin
11
Oct 18, 2019
bookmark_border
This was exactly the comment I'm looking for. The headband looks so uncomfortable in the pictures, too, and for me, comfort comes first. Thank you a lot.
Oct 18, 2019
Tippolas
13
Oct 18, 2019
bookmark_border
Yes of course. It's already been returned.
Oct 18, 2019
Tippolas
13
Oct 18, 2019
bookmark_border
Very mature and constructive response. Why are you even here?
Oct 18, 2019
Tippolas
13
Oct 18, 2019
bookmark_border
Glad i could help!
Oct 18, 2019
Qwervy
410
Oct 23, 2019
bookmark_border
the rattling could have been caused by something dropping inside the headphones and rubbing up against the driver, usually a bit of dust or sand or something
Oct 23, 2019
Tippolas
13
Oct 23, 2019
bookmark_border
Dust doesn't rattle. It had to have been a component of the headphone that came loose. I only had them for four days.
Oct 23, 2019
Qwervy
410
Oct 23, 2019
bookmark_border
Could be a little bit of plastic, a chip of a rock, grain of sand, speck of solder.
Oct 23, 2019
Tippolas
13
Oct 23, 2019
bookmark_border
It actually couldn't be any of those things. Four days. I had them for four days. They didn't go on a trail with me. They didn't leave my desk. It was a manufacturer defect.
Oct 23, 2019
Qwervy
410
Oct 23, 2019
bookmark_border
injection moulding leaves little tabs, solder occasionally have bits that come off
Oct 23, 2019
Qwervy
410
Oct 23, 2019
bookmark_border
I'm not trying to say I'm right, I'm just suggesting that that particular point may have been fairly easily fixable.
Oct 23, 2019
See More Reviews