Showing 1 of 138 conversations about:
View Full Discussion
Hi I’m having some issues with my shipment
1. My desktop arrived damaged
2. The holes for the feet of the legs do not align so I can’t get bolts in there securely -
That's by design. If it's severely off center, rotate it 180 degrees. Once it slightly off from the aligned holes, you're good. Pull one side up and start screwing in
One of the feet worked fine but the other didn’t allow me to get the bolts started regardless of flipping or switching legs.
I was able to get one of the bolts in but not any of the other 3 due to the angle the bolt would need to go in
Same thing here. Only one or two bolts go in. Pretty sure another one threaded incorrectly into the leg, so that’s going to be fun 🤬
Did you try to just initially thread it? Don't tighten whatsoever, just get it in the thread. I had to do that for both sides, which looked to be by design
Most of the holes on mine can not be threaded properly. The angle is too severe.
More severe than naveedx983? That picture he has above looks like mine did and it worked, but i had to lift it completely up.