LopedogI forgot to add the escape key is tricky as one socket fit. I had a spare Holtite socket from a another PCB build that fits in but needed to solder it carefully to work.
emdot_pHi, sorry for jumping in an old post/comment, I'm planning to build a board with the DZ60 rev 3 and make it hotswap so I can easily switch between different layouts. I noticed that one hole of the escape key is smaller, I did some research and found this thread, luckily. I read your note that the holtite socket fits. Can I ask what specific holtite socket this is and how does it fair when plugging in/out a switch, does it fit just fine? Hoping you're still active lol. Thanks in advance!
emdot_pOh yes that's what I'm planning to use also, but I'm looking at the one smaller hole of the escape key, as you mentioned you used a holtite socket, was it the 8134 socket? If so, does it fit well?
Btw, that was fast! Thank you for the reply!
jerichmgnFor that particular hole, I soldered it on my boards cause I never planned to switch out the switch from that key. Sorry I couldn't be more help with your question. If you're on Reddit, check the r/mechanicalkeyboards group as someone may confirm if the 8134 socket will work.