Showing 1 of 61 conversations about:
misterman14
50
May 9, 2018
bookmark_border
I have a very old well worn set of Klipsch X10 IEM’s which share this form factor. I keep them because of their isolation properties. I have better multi driver IEM‘s and headphones so thesevwould only be used innoisy airplanes etc where I want to block out as much noise as possible while still getting a good sound. Can someone comment on this comparison? For me this is a good price for a limited use item. I like the X10’s but they are not very revealing.
May 9, 2018
jrub
0
May 9, 2018
bookmark_border
I previously used the X11i and X12i , which I both lost ( :( ) and I ordered the ER3XR off ebay last week. Should get them tomorrow...I could at least let you know how I think they compare based on my memory of the X11/12i (since they are the same drivers as the X10).
May 9, 2018
misterman14
50
May 9, 2018
bookmark_border
Thank you!
May 9, 2018
Be88
0
May 10, 2018
bookmark_border
I also have the klipsch and these have better build quality with the steel body and replaceable /upgradable wires
May 10, 2018
misterman14
50
May 11, 2018
bookmark_border
Did you get a chance to compare them?
May 11, 2018
jrub
0
May 11, 2018
bookmark_border
There was actually an issue with the address on the shipment, so they shipped it back and I just reordered it on Amazon.
May 11, 2018
misterman14
50
May 11, 2018
bookmark_border
Better price than MD? I’m going to get a set...
May 11, 2018
misterman14
50
May 12, 2018
bookmark_border
So it's done anyway. I'll post my impressions against the X10's when I get them. Cheers!
May 12, 2018
jrub
0
May 13, 2018
bookmark_border
No, but I was worried about the comments here on the warranty. And also needed them before a trip this week (MD is shipping in June). Please do post the impressions!
May 13, 2018
Davestef
124
Feb 17, 2019
bookmark_border
How do they compare to the Klipsch’s?
Feb 17, 2019
View Full Discussion