Showing 1 of 2440 conversations about:
univern72
2
Nov 10, 2015
bookmark_border
I just finished assembling my Infinity Ergodox. When I pushed the flash button on the board for the left hand, the screen turned red and I flashed it successfully. However, when I push the flash button on the board for the right hand, the screen turns off completely until I unplug/replug the board into my PC. Also, when changing layers, the screen on the right hand will flash off and on, then take like 4 seconds before pressing keys will output again.
If I flash the left hand, the right hand's keys update, so my keyboard is mostly functional other than the extreme delay between layer changes.
What's up with this? Who should I contact?
Nov 10, 2015
Mapleshilc
43
Nov 10, 2015
bookmark_border
the problem with the right hand turning off, is that its still on, and you can still flash it, its just the screen's red led doesnt work, so it seems like it doesnt work, when i flash my right hand, it seems like its completely off, but, it still flashes properly. and depending which hand you are connected to your computer with, you could just flash that one, but if you connect it with the other hand, it ends up stop working.
Nov 10, 2015
View Full Discussion