Showing 1 of 2440 conversations about:
Hazer
2
Oct 11, 2016
bookmark_border
I soldered all the switches into one of the key pads and started testing it. All of my keys work perfectly, however one acts a little strange and I am unsure if that is normal, or if I have a problem. When I press the key (default) -L1 on the right hand keypad, the LCD panel illuminates a light reddish color and it displays a block cursor. Is this normal? Is it because I possibly have only one layer installed so it cannot go down a layer?
Thanks.
Oct 11, 2016
pcallaghan
11
Oct 11, 2016
bookmark_border
The number on the key pad (other than the base layer) is the layer number. Red is layer 1 by default and layer 2 is blue. I think you are seeing the block number 1, not a cursor.
Oct 11, 2016
View Full Discussion