naveedx983That's by design. If it's severely off center, rotate it 180 degrees. Once it slightly off from the aligned holes, you're good. Pull one side up and start screwing in
LinkOmegaOne of the feet worked fine but the other didn’t allow me to get the bolts started regardless of flipping or switching legs.
I was able to get one of the bolts in but not any of the other 3 due to the angle the bolt would need to go in
naveedx983Did you try to just initially thread it? Don't tighten whatsoever, just get it in the thread. I had to do that for both sides, which looked to be by design
1. My desktop arrived damaged
2. The holes for the feet of the legs do not align so I can’t get bolts in there securely -
Please advise
I was able to get one of the bolts in but not any of the other 3 due to the angle the bolt would need to go in