Sennheiser PC37X randomly goes bad after disconnecting the cable ?
Greetings, Yesterday I was using my headset like normal with my macbook, just listening to music and on a call with people like usual, and the headset was perfectly fine. The stock wire that came with the headset is extremely long and yesterday it annoyed me very much that it kept getting tangled with itself, so I decided to see if the cable is replaceable. I pulled out the cable from the headset and saw the adapter, and looked online for a replacement. Upon plugging it back in, the audio sounded extremely muffled and washed out. Im not sure what I did wrong to make it mess up like that as I've always taken good care of it, ive had it for about 2 years and its always just been chilling on my desk, but anywho I thought the cable just went bad and ordered a replacement. The replacement came, and the issue is still persistant, so I am not sure what the issue is I've tried multiple different headsets and the issue is not with the port, and I also tried it with my windows laptop and...
Apr 23, 2024
On your debate front... that would be a tough one. I haven't personally been able to hear any of their line but they certainly are interesting designs. I was a big dynamic driver guy for a while (most of my IEM's fall in that paradigm, a few exceptions) and wanted to go whole hog on the BA front. The nicest BA I've used in the past was the UE Triple-fi 10... still one hell of a good IEM for Rock music IMO.
Uzuzu is correct, though, apart from his heresy that ether flows compare with his no mame mid fi monstrosity over-ears.
The problem with iem's is space. You can only do so much with technology, in such a small format...And I preferred shure se535's, to the original k10's, at almost three times the latter's price, over the former's....
Having said that, there's a world of difference between shure se535's, and iem's around the $100 mark...
the k10 is CNC milled not 3D printed
The classic are partially cnc, none of the Noble line is 3d printed.
Fully cnc products might be appreciated by those that would rather have a housing built with more time and effort than an injected molded housing shot out of a machine at a rate of 300 units a minute.
Different strokes for different folks