Showing 1 of 264 conversations about:
View Full Discussion
My tester have already been shipped aswell, but I'm yet to recieve it. It will probably take a couple of days.
I'm wondering if anybody who already got theirs would mind posting a couple of pictures here, just so we could get a better look at the switches. :p
Thanks for the photos! Looking at the Gateron switches, if you want to use these switches on the PCB, you'll need to clip the two small plastic prongs on either side of the big plastic nub or it wouldn't fit the PCB.
If it's like the sample I got, I think they'll put the nub holes in actually. Should be good to go :)
Thank you. It looks just like the pictures Massdrop provided.
I don't mind if a switch or two are out of their normal place. As long as everything works fine then I'm happy.
I was looking at your photo. The nub hole is there, but the hole for the small prongs are not. Unless you mean you got a different sample? Anyway cutting off the prongs is not a big deal.
We're talking about the two little support prongs right? Not the big middle nub. It's pretty likely my picture is just not good, but I'll check on Monday to make sure the pcb has them
What kind of O Rings are included? I like them and want to buy more.
Alright, the one in the pics I got didn't have them, but the one sitting on my desk does have them. Someone who got theirs already will have to verify if they made it to the final revision or not.
Thanks for checking, Alex.