SakeJamsGeneric printing worked for me. Try a different computer / USB slot / cable. Also, try not to connect it to a USB hub while flashing. The only issue I had was that it showed printing and never actually "finished" the print. I just wait a minute or two and then pulled the usb. It took the config. Hope that helps.
VonSwoopingtonokay so i finally managed to get it to flash but now i'm having a problem where the rgb won't turn on on the back. I set it up exactly the same as in the guide, and fn3/fn4 should turn it on and off, but instead it just makes the windows disconnect noise when i try to turn it on. i've reflashed several times and i'm not sure what's going on tbh
SakeJamsThat is odd. I haven't run across that issue. Maybe you have a broken PCB? I thought I had one as well but it took me a couple tries to ensure the board flashed properly. Massdrop sent me a replacement board in the meantime but I'm shipping it back. You can reach out for a new one but they do want the broken one shipped to them. If you've already soldered everythingthen that's going to suck.
SakeJamsHere is the steps I took to get mine flashed.
1. Get layout finished... http://www.keyboard-layout-editor.com/#/gists/850e6b96f87499dfe1d944c54194c5b1
2. Copy raw data from layout in raw data tab.
3. Go to https://tkg.io/#
4. Select RedScarfIII from list.
5. Select Simple as Layer Mode
6. Paste Raw Data in Composite Layer
7 . Follow Directions in Creating Your FN Layer In Keyboard Layout Editor @
https://www.massdrop.com/talk/732/programming-the-red-scarf-keyboards
8. Download EEP File.
9. Make sure keyboard is unplugged. Hold down ESC key. Plug Keyboard in. This puts the keyboard in EEP flash mode.
10. Open saved EEP File in Notepad
11. When you plugged in the keyboard in EEP flash mode it created a printer called "Generic / Text Only)
12. Print the EEP file. If you watch the print Queue. It never seems to finish. I just waited like 60 seconds and pulled the plug.
13. Wait 10 seconds plug in keyboard.
POOF all programmed.
CyypherI've done exactly this and it hasn't worked. I've never had a problem with flashing or reflashing my old RS96. I even went as far as buying batteries for the remote and trying to use that but it hasn't worked. The only thing I can assume is that the pcb is borked.
It makes the windows disconnect sound when I try to turn it on, both with the flashed layout and the remote. Can't really understand what I'm doing wrong here.