Showing 1 of 103 conversations about:
The_Girthquake
19
Oct 9, 2020
bookmark_border
So, when plugging this board into my pc to test it without switches, I get no response from windows. Is this normal? Do I need to flash this beforehand to get windows to acknowledge it? Or is this dead? @SpencerL can you assist?
(Edited)
Oct 9, 2020
andtar
8
Oct 9, 2020
bookmark_border
I have same issue here, my both PCBs seems dead. Are they dead or maybe did they forget to flash the microcontroller?
Oct 9, 2020
The_Girthquake
19
Oct 9, 2020
bookmark_border
I noticed my issue was due to the ribbon cable. Make sure he blue side of both connections is facing up.
Oct 9, 2020
andtar
8
Oct 9, 2020
bookmark_border
I checked that already :( PCB connector is receiving voltage but nothing happens when I plug it in. Same on both PCBs.
Oct 9, 2020
The_Girthquake
19
Oct 9, 2020
bookmark_border
Hmm. From that point, place an rma with drop. I had my bad board replaced. They'll make you ship your whole kit back but they can get you a new one.
Oct 9, 2020
View Full Discussion