*Help* Screw in stabilizers not fitting in Dropshift V2 keyboard
I'm trying to build a mechanical keyboard with screw in stabilizers, I've build some mechanical keyboards with click-in stabilizers, never with screw in. Somehow one of the pins of the metal top-part collides with the screw in stabilizer of the numpad "enter key". I already tried grinding of a bit of the pin that collides with the stabilizer, but unfortunately I can't make it fit/close properly. You can see that the pin of the toppart leaves a mark on the bottompart of the stabilizer, see picture 2. What am I missing? Using Durock V2 in a Dropshift fullsize V2. See pictures below, thanks in advance!
Apr 23, 2024
My next to last row of keys (ZXC...) when I press one of any key in the row, the entire column that the key is wired to gets typed. If I press B is does something like "6YHB ". If I leave the keyboard unplugged for a while, this row if keys works normally for a minute or so.
Also, my very bottom row of LEDs are continually on, and I can't control them using the shortcuts I made with a QMK firmware. The lighting control works for the RGB and other rows of LEDs.
I've tried cleaning up all the solder points I can see and look for any globs, and cleaned up the flux but both of these problems still happen. Anyone have any suggestions?