Showing 1 of 315 conversations about:
GetThatDrop
0
Mar 26, 2016
bookmark_border
Is anyone else having issues with getting the three RSHFT switches to work? Using the custom keymap I should have END RSHFT UP on the right of "/" but I'm getting END RSHFT RSHFT.
Mar 26, 2016
irae
12
Mar 29, 2016
bookmark_border
That's weird. I didn't solder all this switches, going for a large shift key instead. But nowhere in the source code I found the combination you mentioned.
Mar 29, 2016
GetThatDrop
0
Mar 29, 2016
bookmark_border
Thanks for looking into it! You can see the keys in keymap_custom.c in the s60-x folder from the firmware you posted, it has the three different keys under rshft. If you look at the pcb there are actually 4 holes for switches, but I'm assuming that the middle two are supposed to be the same and the outer ones different.
When I load keymap_custom and short the pin holes with a wire I get END RSHFT RSHFT RSHFT instead of END RSHFT RSHFT UP.
The reason I want all three different ones is because I want arrow keys in the bottom right and the left RSHFT lines up with what will be the down key in the bottom row and I want the UP key to be the FN key. I could have my UP arrow replace END and my FN replace RSHFT, but the arrow keys would be staggered so if the hardware allows the configuration I want, it would be great to find a software solution.
What I want: END | UP | FN LEF | DWN | RIGHT
What I get: END | UP | UP LEF | DWN | RIGHT
What I could have(staggered): | UP | FN | FN LEF | DWN | RIGHT
Mar 29, 2016
jbyoung
20
Mar 29, 2016
bookmark_border
I believe that you cannot have three switches in the right switch position.
Mar 29, 2016
View Full Discussion