The table in the product image shows that the Initial force is 38g/45g/55g and Actuation Force is 55g/62g/67g, but the Force-Travel-Diagrams show that the operating force is 38/45/55, while bottom-out force is 55/62/67. Moreover, the product detail shows "Operating force" is 15g - no idea where does this figure comes from. So there is a big mix-up between the Inital force, Operation force (Operating force), Actuation force, Bottom-out force...Can you please make this more clear?

Old Picture Of Mics I Used To Have/had Access To A While Back "Which mic should I buy to record my keyboard sound tests? Do I have to sound-treat my room to make my recordings better? Should I not have my mic attached to the desk I’m typing on to avoid picking up desk noise?" Whether you’ve had one of these questions or all of these questions (just like me when I first started), I’m hoping that this article will give you sufficient answers to the questions we think about when recording our sound tests. Like with the majority of my content, these are just my thoughts, and I encourage you to continue to research your questions by watching videos or reading other articles. Just because I give my opinions in this article doesn’t mean that other people’s opinions are wrong, or that you should just listen to me. I'm not an expert at any of this stuff, and I'm just scratching the surface of audio. There is so much that goes into mixing and recording that to pretend that I know...

The Migra TKL Prototype by Thebloodyez “This is my keyboard. There are many like it, but this one is mine.” - William H. Rupertus. In another life, if Major General William H. Rupertus, the Marine who coined the United States Marine Creed, had been a keyboard enthusiast, we might've gotten this line instead. All joking aside, this has been an article that I’ve wanted to write for quite some time. There are many reasons why we love the keyboard hobby, and today, I wanted to introduce you to one of mine—prototype keyboards and helping keyboard designers by joining prototype runs. Now, it’s not risk-free, and one should weigh the pros and cons of joining a prototype run, so I encourage you to pay attention to the disclaimer portion of this article. I know that there are prototype runs for keycaps, switches, and other cool things in our keyboard hobby, but for this article, I’ll be focusing only on keyboards. Also, please know that not every prototype run will be handled...