*Help* Screw in stabilizers not fitting in Dropshift V2 keyboard
I'm trying to build a mechanical keyboard with screw in stabilizers, I've build some mechanical keyboards with click-in stabilizers, never with screw in. Somehow one of the pins of the metal top-part collides with the screw in stabilizer of the numpad "enter key". I already tried grinding of a bit of the pin that collides with the stabilizer, but unfortunately I can't make it fit/close properly. You can see that the pin of the toppart leaves a mark on the bottompart of the stabilizer, see picture 2. What am I missing? Using Durock V2 in a Dropshift fullsize V2. See pictures below, thanks in advance!
Apr 23, 2024
I very much needed to do a jailhouse mod to my mx greens so I could have a good school keyboard. So today ill be showing you how to desolder a plank pcb although they will all be done the same just with varying sizes.
Before you start make sure you are careful while doing this its very easy to burn yourself and it is possible to fry your pcb while doing this so make sure you have a good heat and are really careful :)
To start you will need a few things
1. a soldering iron
2. a desoldering pump
3. something to clean the iron
This is what my keeb looks like :3
First you will have to start by taking off the keycaps
then just repeat for every. single. solder point... (I had my heat too high here so try to find the right heat for you)
also I damaged my desk to make this so I hope you guys enjoyed this