C3 Tangerines have an orange/red casing which dims the blue quite a bit

Thanks to StoryboardTech’s fantastic article, you finally learned how to solder! Or at least, you’re committed to learning. So, what’s next? Well, if you’re brave enough, why not learn how to desolder as well? And when you feel confident with that, how about Mill-Max? You don’t necessarily have to know or learn how to solder before learning how to desolder or Mill-max, but in my opinion, getting comfortable with soldering is a great step towards learning how to do the other two, and if you know how to solder, you can practice desoldering and mill-maxing to your heart’s content since you’ll already have the tools from learning how to solder! Well, at least most of the tools. Let’s start off with the good ol’ disclaimer section first, however. Disclaimer These are my own opinions and my own thoughts, and if I’ve learned anything in life, it’s that we all do things in slightly different ways. Whether it be deadlifting, desoldering, Mill-Maxing or even baking...

Old Picture Of Mics I Used To Have/had Access To A While Back "Which mic should I buy to record my keyboard sound tests? Do I have to sound-treat my room to make my recordings better? Should I not have my mic attached to the desk I’m typing on to avoid picking up desk noise?" Whether you’ve had one of these questions or all of these questions (just like me when I first started), I’m hoping that this article will give you sufficient answers to the questions we think about when recording our sound tests. Like with the majority of my content, these are just my thoughts, and I encourage you to continue to research your questions by watching videos or reading other articles. Just because I give my opinions in this article doesn’t mean that other people’s opinions are wrong, or that you should just listen to me. I'm not an expert at any of this stuff, and I'm just scratching the surface of audio. There is so much that goes into mixing and recording that to pretend that I know...