*Help* Screw in stabilizers not fitting in Dropshift V2 keyboard
I'm trying to build a mechanical keyboard with screw in stabilizers, I've build some mechanical keyboards with click-in stabilizers, never with screw in. Somehow one of the pins of the metal top-part collides with the screw in stabilizer of the numpad "enter key". I already tried grinding of a bit of the pin that collides with the stabilizer, but unfortunately I can't make it fit/close properly. You can see that the pin of the toppart leaves a mark on the bottompart of the stabilizer, see picture 2. What am I missing? Using Durock V2 in a Dropshift fullsize V2. See pictures below, thanks in advance!
Apr 23, 2024
- 4 edges LEDs
- 21 tops LEDs
- 8 right LEDs
- 23 bottom LEDs
- 8 left LEDs
However in my tests using QMK (based of default_md keymap), I was able to map only 22 bottom LEDs (instead of 23) starting from right to left at id4/bit 6 until id4/bit 28. When I configure id4/bit 29 is activates the bottom left edge LED. What's id the correct underglow LED distribution? Is there any documentation with the correct LEDs mapping? It's also worth notting that the comments in https://github.com/Massdrop/qmk_firmware/blob/master/keyboards/massdrop/shift/keymaps/default_md/keymap.c#L288-L303 are unreliable. Don't appear to have been copied from another keyboard, as dropshift uses until id5, and underglow starts at id3 instead of id2.