Showing 1 of 380 conversations about:
Hurricane
11
Jun 8, 2017
bookmark_border
Word of warning....
So I bought one the first drop, the one where the light was selling for $25. Well I used the light like a grand total of 3 times and it has already stopped working. Not sure why it hasn't and I'm not sure if anyone else has had any issues with theirs. The light is built solid and I really wanted to have it for a long time. It looks cool but it hasn't even been long enough to get a patina and it's already broken.
Jun 8, 2017
Teletin
131
Jun 9, 2017
bookmark_border
I have one from the first drop too and use it daily since it artived without any problems. Did you check everything like a new batterie, is the head of the light screwed really tight and things like this?
Jun 9, 2017
Hurricane
11
Jun 9, 2017
bookmark_border
Yeah unfortunately I trouble shot every way I could possibly think of. I even tried like four different brand new batteries. It's looking like she's dead. I did read in one of the comments here that someone had a light that would sometimes work and sometimes wouldn't though. Maybe it will decide to work sometimes.
Jun 9, 2017
Bassman
29
Jun 10, 2017
bookmark_border
If you contact Massdrop they will replace it.
Jun 10, 2017
Hurricane
11
Jun 10, 2017
bookmark_border
I already contacted them, they said they cannot replace it.
Jun 10, 2017
Teletin
131
Jun 12, 2017
bookmark_border
That's not fair, write a mail to Support@lumintop.com and tell them whats happens. I think they could help you!
Jun 12, 2017
allent
58
Jun 25, 2017
bookmark_border
Same here. In mine, the screw ring inside the switch cap was a turn loose. I just used a pin to twist it tighter, and it has been working fine for several months now.
Jun 25, 2017
Hurricane
11
Jun 26, 2017
bookmark_border
How did you end up doing that?
Jun 26, 2017
allent
58
Jun 26, 2017
bookmark_border
Unscrew the switch end of the light. There is a flat piece of metal that looks like a washer that holds the switch in the cap, and the spring pokes up through the middle of it. That has couple small holes or dimples that probably are intended for a special tool, but I used the point of a straightened safety pin. Just put the tip of the pin in one of the holes and try spinning the washer to tighten it. If it is loose, it will move pretty easily.
Jun 26, 2017
Hurricane
11
Jun 27, 2017
bookmark_border
Unfortunately that didn't seem to do anything :(
Jun 27, 2017
View Full Discussion