Have you noticed the flaw in the Shift V2 case?
I recently decided to try adding screw-in stabs to my Shift V2. As this was my first time adding screw-ins, it took me about 45 minutes to get them on the PCB. The next hour was then spent unsuccessfully trying to get the PCB to sit nicely in the top of the case. I started unscrewing some of the stabs, trying to figure out which one was the problem. I did also manage to figure out that it's best practice to have the screws a little loose when you go to pop the PCB in the case. But that only worked for four of the five stabs. The fifth stab, the Num Enter stab, would sit properly. Once I got it narrowed down to that stab, I started looking at the case itself. That's when I found the problem. There is a little post that interferes with the screw-in stab's screw (pictures included; you can see the damage from the screw being mashed into the post). I assume this is a carryover from the V1 case, for which the included PCB did not have holes for board mounted stabs. So now the questions:...
May 26, 2024
As for NPKC not responding, I believe most of the time (as in 99%) MD would respond to these kinds of queries more since they are in charge of the drop. Majority of these suppliers really course through MD as well for any concerns since it streamlines and simplifies things for their company. Though I do wish more companies responded and focused more on a quality customer service experience over just selling.
As for the wrist rest, I'll wait for it to get to the lowest price (it is now and I'm getting one) and then probably get one! It's so cheap and I'm willing to take a chance on this for the low price!