shopping_cart
Showing 1 of 138 conversations about:
Xyzac
521
Apr 5, 2018
bookmark_border
@Zeal Do these come with rubber washer to prevent shorting on the PCB? https://www.reddit.com/r/mechmarket/comments/89extr/vendor_gmk_screwin_stabilisers_group_buy/
Apr 5, 2018
Zeal
417
Super Fly Zeal PC
Apr 5, 2018
bookmark_border
No, but there are only a few PCB designs where shorting is an issue. Easily fixed with a small cut of paper or a sandwich bag.
Apr 5, 2018
lifeonadklein
148
May 2, 2018
bookmark_border
How do you determine if your PCB may be affected by shorting from these stabs?
May 2, 2018
Photoelectric
99
May 2, 2018
bookmark_border
It’s super easy: when you are about to put the nut on each stabilizer “foot”, see if it will touch a trace. If it will, use a small piece of electrical tape. If not, no tape or washer are needed.
May 2, 2018
lifeonadklein
148
May 2, 2018
bookmark_border
Thanks! That makes perfect sense.
May 2, 2018
AlphaAnt
6
May 2, 2018
bookmark_border
That's exactly what I did when I installed these on a 1-Up NerD60, otherwise it prevented one of the LEDs from coming on.
May 2, 2018
carnageasada
3
May 4, 2018
bookmark_border
This obviously wouldn't be an issue with your Zeal60, correct?
May 4, 2018
Zeal
417
Super Fly Zeal PC
May 4, 2018
bookmark_border
Never an issue with the Zeal60.
May 4, 2018
View Full Discussion